CONTOUR SHUTTLE ADOBE CC HOW TO
CONTOUR SHUTTLE ADOBE CC SERIAL NUMBER

Hold the Cursor Speed Button (DPI) and COPY button until the LED animation shows the current mode.

CONTOUR SHUTTLE ADOBE CC SERIAL NUMBER

If your serial number starts with 582, 592, 860 or 880 please follow these steps: Repeat holding the COPY and PASTE button down at the same time until the right LED is flashing for your requirements. Afterwards an LED will flash between the COPY and PASTE button.Ī LED flashing on the farthest right side indicates it is in MAC mode.Ī LED flashing on the farthest left side indicates it is in PC mode. Hold down the COPY and PASTE button at the same time for a few seconds. If your serial number starts with 580 or 590 please follow the steps below: The RollerMouse may be in an alternate mode of either PC or MAC mode.

CONTOUR SHUTTLE ADOBE CC HOW TO

To learn how to disable the driver, click here or scroll down to solution #15. If you have the Contour driver installed, please disable first before proceeding with the following instructions. Make sure the wires are still connected, screw the board back on, making sure it’s nice and tight to reduce excess play with the buttons, snap the buttons back in place, and replace the screws on the back.Ĭontact us if you need further assistance or if you have any additional questions. When placing the new buttons on, line up this notch just in between the scroll wheel and the post where it’s connected. Unscrew these 4 screws to separate the board from the buttons. Lift up the button housing from right to left as there are 2 plugs on the left side. Turn the unit over, and pry the button cover off with a flathead screwdriver. These two middle screws need to come out from the underside.

If you do not have the tool a flathead screwdriver is a good replacement. _ Please disconnect your RollerMouse Red from any power source before proceeding with the following instructions.Ī simple twist in this notch here with the tool that came with the RollerMouse will remove the wrist pad. You’ll need to send us the unit for us to personally repair, and we’ll promptly send it back to you within a few days of receiving it. _ This can also be remedied if you contact at us to create a repair support case. Productivity Analysis of 6 Popular Ergonomic Mouse DesignsĬontact us to receive extra button caps for the button that is sticking to proceed with the instructions.

Contour shuttle adobe cc