Above ground sewage ejector system install#
Above ground sewage ejector system code#

In a sewage system, you are generally dealing with solid and semi-solid liquids. Both are pushed up by gravity when the pump turns on, and close after the pump turns on.įor sewage applications, a Ball Check Valve is popular to use as they stand up better to the tough conditions. The main difference between a swing and flapper valve is that the swing valve is usually a hinged plastic cover while the flapper is just a piece of rubber. This keeps the water or sewage that is in the vertical part of the pipe from coming back down. This valve is pushed open when the pump pushes water through a certain direction, and then closes as the pump stops. Most of the time, these product use what is called a 'swing valve' or 'flapper valve' to control the flow of water.

Above ground sewage ejector system code#

In Sewage systems, these valves are generally required by code to prevent sewage from draining back into the basin. Installing one of these valves will drastically reduce the stress that is put on your pump and save energy by limiting the amount that the pump needs to run.Ī Sump & Sewage Check Valve is very easy to install, and even though they are not usually code, it is good practice to make sure you have one included in your system. If you do not have a Check Valve installed, it will cause your system to work much harder and more often to pump out the same amount. These valves help to make sure that the water that was pumped out does not come back into the pit. Is Al Gore's mansion downhill from this place by any chance?A Sump & Sewage Check Valve is a plumbing product that is specifically used in a Sump or Sewage Pump system.

I'd like to hear back how you work it out. Also, one must consider the fact that he may be starving millions of the critically endangered blue-bottle fly and other insects. Your customer is a real prince for denying his kids a Harvard education so he can pay for a virtual Roman aqueduct to carry away his poopy. Now, I'm thinking that the only reason to run the drains to the downhill side of the house would be to utilize the downhill splash method of sewage disposal. The septic tank was a hillside briarpatch that couldn't be clumb by two-legged mammals. At some point I asked the lady of the house where the septic tank was, and she pointed off to the south where the lot dropped off at a 45 degree angle. They owned forty acres in that direction, which I learned when I did some plumbing for them. Two doors down from where I used to live, the folks had a property at the top of the hill on a ridge that sloped down gradually in all directions except for behind the house where it dropped off precipitously. I considered a watering trough heater, but would rather have something made for the purpose, both to resist freezing and UV rays.Īny ideas out there? Thanks have a nice weekend! I've been looking and calling various pump system companies asking about an outdoor, above-ground system with a heater, but so far haven't found one. I'll have to pour a pinned slab on the mountainside to provide a level place for the unit, I know, and run the electrical in conduit, but hope to avoid a structure. The homeowner doesn't want a structure built to house one because of the expense, which on the side of the mountain would be considerable. I'll need a sewage pump system on the bluff side, but there's no practical way to bury one.

Above ground sewage ejector system install#

I'm going to install a typical in-ground septic tank and field line in the front yard, which fortunately has enough soil for that. The plumbing drains exit on the bluff side, and the mountain below is steep and of rock. I have a customer with a vacation home built on the edge of a rock bluff.